Advanced search
All categories
Add new FAQ
Add question
Open questions
Login
- Sign up
- Login

General Questions

through AT command

admin

2019-12-04 08:01

0 Comments

at-cmd /dev/ttyUSB2 AT+CSQ(check the signal strength,special use for OS system)

Related entries

MC7455查询模块相关信息和AT指令调用
通用AT指令
通用AT指令
通用AT指令
通用AT指令

Rate this FAQ

☆ ☆ ☆ ☆ ☆

Average rating: 0 (0 Votes)

You can comment this FAQ

Comment this FAQ

Please enter the captcha code

Tags

flash

Records in this category

Neither the cell phone nor the laptop could not find the SSID of wireless bridge.
Does the wireless bridge support the could management.
Which antennas connect with wireless bridge.
What is wireless bridge.
Forget the login password.
Forget the wireless password
Whether to support repeater
Unable to log in to the 192.168.1.1 management page
uboot supports entering flash mode
Repeater
Supported VPN functions
Default firewall
Default SSID
Default management IP
Default login password
Whether to enable SSH function
Telnet function is open
Access Controller can't find AP
How to use AP(AP522,AP622,AP822)
cloud login identification
through AT command
through AT command
through AT command
through AT command
through AT command
MC7455module,how to check the module information and apply AT command
Which 4G lte modules are supported by ZBT OS
For EC25+WE826-Q device, how to get the maximum rate?
How long is needed for WE826-Q to change from 4G to WAN?
How long is needed for WE826-Q to be on ?
Why does the WE826-Q restart always?
How to use APN to dialing up?
Why can not dialing up for the 4g sim card?
Why the network rate is so slow?
How to fill the country?
For EC25+WE826-T2 device, how to get the maximum rate?
How long does it take to switch between 4G and WAN ports?
How long does the OS system normally start?
Does WE826-T2 support watchdog
How much memory and flash memory does the AR9344 support?
What is the difference between QCA9563 \ QCA9561 \ QCA9531?
How much memory and flash memory does QCA9561 \ QCA9563 support?
How much memory and flash memory does QCA9531 support?
How many cores is the IPQ4019 / IPQ4029?
Did IPQ4019 and IPQ4029 supports MU-MIMO（WAVE2）?
How much memory and flash memory does the IPQ4019 / IPQ4029 support?
What is the difference between IPQ4019 and IPQ4029?
Does MT7615N support MU-MIMO (WAVE2)?
What is the difference between MT7612EN and MT7613BEN?
How much NAND FLASH does the MT7621A/MT7621DA support?
What is the difference between MT7621A and MT7621DA?
How much FLASH and RAM does MT7621A support?
How much flash and RAM does MT7620A support?
What is the difference between MT7628AN and MT7628DAN?
How much FLASH and RAM does MT7628AN / MT7628NN support?
Why some openVPN can't dial up?
Does 4G Device support 4G SIM7600SA-H Module now?
4G routing port forwarding access to external network IP and external port Why can't access the corresponding internal network IP + internal port?
How long does it take for the 4G router to automatically connect to the Internet after the network is restored?
Is there a Gigabit AP device?
Which device support VPN function?
Does WE826-T2 support broadband control?
Can the OS firmware use 3G traffic when the 4G is bad?
Can the wireless bridge via the wire to get intenet?
Can the OS firmware change the time zone?
Can the OS firmware custom DNS?
Can the wireless bridge transmit vlan data?
Does our product support IPV6?
Does DDNS for openwrt firmware support no-ip?
Can we find out the version number of the 4G router module?
What languages does the OS firmware support?
Does the 4G of the 4G router support the timed restart function?
Is the 5G bridge wave1 or wave2?
Are 5G bridge based on OFDM?
Which model is suitable for 80-100 users at the same time?
Does the OS firmware support Open VPN?
Support CentOS, Ubuntu, Linux system?
During 4G network operation, operator information will be on the web?
Support captive portal function?
Support authentication function?
If our SIM card need to input PIN CODE, is it available?
For port forwarder quanitity is limited max.10, can you make more quantity?
APN information and ISP information is necessary for dialing up Internet?
Customer need to set ISP?
Device support check storage audio, video etc. information via Ethernet port and wifi?
Yes, because sim card need to test the Internet
Does it can select the strongest signal ISP automatically?
Does it can select the strongest signal ISP automatically?
Is it support IPTV?
Is it support Vlan?
Between several APs , how to make terminal devices (mobile phone or computer) switch and connect the wifi of these APs automatically?
Is it support ipsec?
EC20/EC25 series modem select Gobinet or QMI dail up mode
Latest firmware support SIMCOM module?
Does the OS support external USB or SD card to expand memory
Is it support npnp?
What is the default mode of WPA-PSK?
How is the status of light when reading the 4G card
How is the status of light when reading the 4G card
What are the ways for the OS to access the hard disk
What are the common interfaces of HDD
Does OS firmware support wireless dongle
Bad speed of the bridge that mounted in elevator
Now the USB lights of WE826 series product firmware are 4G lights (it will flash when it induces the module)
OS All the AP are Fit AP, All OPs are Fat AP
Can not enter into the uboot of WE5926
It still cannot bridge even though pressing "reset" button of the AB terminal of the bridge until the light flashes and resets.

1 user online | 1 Guest and 0 Registered
FAQ Overview
Sitemap
FAQ Glossary
Contact

powered by phpMyFAQ 2.9.13